ABB 615 Series ANSI, Technical Manual

Page: 535 / 713

Section 7
1MAC050144-MB C
Control functions
528 615 series ANSI
Technical Manual
7.3.7 Settings
Table 432: 25 group settings
Table 433: 25 non-group settings
Parameter Values (Range) Unit Step Default Description
Live dead mode -1=Off 1=Both Dead Energizing check mode
1=Both Dead
2=Live L, Dead B
3=Dead L, Live B
4=Dead Bus, L Any
5=Dead L, Bus Any
6=One Live, Dead
7=Not Both Live
Difference voltage 0.01...0.50 xVn 0.01 0.05 Maximum voltage difference limit
Difference frequency 0.001...0.100 xFn 0 0.001 Maximum frequency difference limit
Difference angle 5...90 deg 1 5 Maximum angle difference limit
Parameter Values (Range) Unit Step Default Description
Operation 1=enable 1=enable Operation Off / On
5=disable
Synchro check mode 1=Off 2=Synchronous Synchro check operation mode
2=Synchronous
3=Asynchronous
Control mode 1=Continuous 1=Continuous Selection of synchro check command or Continuous control
mode
2=Command
Dead line value 0.1...0.8 xVn 0.1 0.2 Voltage low limit line for energizing check
Live line value 0.2...1.0 xVn 0.1 0.5 Voltage high limit line for energizing check
Dead bus value 0.1...0.8 xVn 0.1 0.2 Voltage low limit bus for energizing check
Live bus value 0.2...1.0 xVn 0.1 0.5 Voltage high limit bus for energizing check
Close pulse 200...60000 ms 10 200 Breaker closing pulse duration
Max energizing V 0.50...1.15 xVn 0.01 1.05 Maximum voltage for energizing
Phase shift -180...180 deg 1 180 Correction of phase difference between measured U_BUS and
U_LINE
Minimum Syn time 0...60000 ms 10 0 Minimum time to accept synchronizing
Maximum Syn time 100...6000000 ms 10 2000 Maximum time to accept synchronizing
Energizing time 100...60000 ms 10 100 Time delay for energizing check
Closing time of CB 40...250 ms 10 60 Closing time of the breaker