YASKAWA CIPR-GA50C series, Техническое руководство

Страница: 80 / 766

3.4 Main Circuit Terminal Block Wiring Procedure
80 YASKAWA SIEPC71061753A GA500 Technical Manual
• Do not let strain on the wiring cause damage. Use a strain relief near the wiring to release the tension. Refer to
Figure 3.31 for an example.
A - Cable clamp
Figure 3.31 Strain Relief Example
Table 3.5 Recommended Wiring Tools
Screw
Size
Screw Shape Wire Gauge Adapter
Bit
Torque Driver Model
(Tightening Torque)
Torque Wrench
(Tightening Torque)
Model Manufacturer
M3 - Bit SF-BIT-SL 0,5X3,0-70 PHOENIX CONTACT
TSD-M 1,2NM
(0.3 - 1.2 N∙m
(2.7 - 10.6 in∙lb))
-
M4 - Bit SF-BIT-SL 1,0X4,0-70 PHOENIX CONTACT
TSD-M 3NM
(1.2 - 3.0 N∙m
(10.6 - 26.6 in∙lb))
-
M5
*1
≤ 25 mm 2
(AWG 10)
Bit SF-BIT-SL 1,2X6,5-70 PHOENIX CONTACT
TSD-M 3NM
(1.2 - 3.0 N∙m
(10.6 - 26.6 in∙lb))
-
≥ 30 mm 2
(AWG 8)
-
4.1 - 4.5 N∙m
(36.3 - 39.8 in∙lb)
*2 *3
M6
(WAF: 5 mm)
- Bit SF-BIT-HEX 5-50 PHOENIX CONTACT -
5 - 9 N∙m
(44.3 - 79.7 in∙lb)
*2 *3
*1 When you wire drive models 2042, 2056, 4031, 4038, 4044, and 4060, select the correct tools for the wire gauge.
*2 Use 6.35 mm (0.25 in) bit socket holder.
*3 Use a torque wrench that can apply this torque measurement range.
■
Main Circuit Terminal Block Wiring Procedure
When terminals R/L1, S/L2, T/L3, -, +1, and +2 have IP20 protection covers, remove them.
1.
Put a wire with prepared ends into the main circuit terminal block.
Look through the opening in the drive case to make sure that you correctly installed the wires into the
terminal block.
Figure 3.32 Install the Electrical Wire
Note:
There is a jumper between ter1 and +2. Remove the jumper, then wire to ter1 and +2.