Shihlin electric SDP Series, Руководство пользователя

Страница: 4 / 555

iv
Never stack products which is beyond limitation.
Do NOT hand carry the cable, motor shaft, and encoder when deliver the servo motor.
Servo drive and motor must be installed on the location with enough bearing capacity.
Do NOT stand or put heavy staff on the product.
Ensure the product is installed correctly as specified in this manual.
Inside the protective chamber, a specified space must be reserved between the servo drive
and other equipment.
Do NOT install, run the damaged or component missing servo drive and servo motor.
Do NOT congest the vent of servo drive. Otherwise, it may cause a malfunction.
Do NOT drop or strike the servo drive and servo motor as they are precision machinery.
Consult with Shihlin Electric system service representative if you need keep the product for
a long period without using.
(2)
Wiring
Do wiring carefully, otherwise, it may cause error on servo motor.
Do NOT install phase-in capacitors, surge absorber, and EMI noise filters between the
servo drive and servo motor.
Connect the servo drive and motor correctly(terminal U,V,W), otherwise, it may cause
malfunction of servo motor.
Connect the servo drive output(terminal U,V,W)and servo motor input(terminal U, V, W)
directly, Do NOT connect them by electromagnetic contactor, otherwise, it may cause
abnormality or fault.
Do NOT put the diode which control the output signal in wrong direction. Otherwise, it may
cause malfunction: no signal output and protect circuit is disabled.
Fasten the cable which is connect to the terminal block with correct torque force. Otherwise,
it may cause overheat on the cable and terminal block.