Lighthouse Raymarine gS 195, Инструкция по установке и эксплуатации

Страница: 77 / 440

5.3 Flush mounting the display
For flush mounting you must rebate the mounting
surface.
D12706-1
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Before modifying the mounting surface, refer
to the dimensions supplied in this document to
ensure there is enough space for the display and
all cables.
3. Fix the supplied mounting template to the
selected location, using masking or self-adhesive
tape.
4. Using a suitable hole saw (the size and position
is indicated on the template), make a hole in each
corner of the cut-out area.
5. Using a suitable saw, cut along the inside edge
of the rear casing cut-out line indicated on the
template.
6. Follow the rebate cut-out line on the template to
cut a rebate around the hole with a depth of 8.5
mm (0.33 in), to accept the display.
7. Ensure that the unit fits into the removed area
and then remove any rough edges.
8. Affix the supplied gasket onto the rear of the
display and press firmly onto the flange.
9. Connect the power, data and other cables to the
unit.
10. Attach the supplied mounting brackets to the
rear of the display using the supplied fixings, as
shown in the diagram below. Use one bracket for
each side of the display.
D12723-2
Note: Refer to the 5.1 Bracket mounting hole
locations section for details of the location of the
bracket mounting holes on the rear of your display.
11. Secure the display using the provided mounting
fixings (bolt, washer, lock nut and foot. In 4
locations.
Depending on the thickness of the mounting
surface the washer and lock nut may be located:
1. between the mounting bracket and mounting
feet (as shown in (1) and (2) below, or
2. after the mounting bracket as shown in (3)
and (4) below.
1 2
3 4
D13043-1
12. Using a suitable allen key, tighten the bracket
mounting bolts so that the feet are tight against
the rear of the mounting surface.
Mounting
77