Lighthouse Raymarine gS 195, Инструкция по установке и эксплуатации

Страница: 274 / 440

On-screen TVG controls
Touch only and HybridTouch multifunction displays
have on-screen TVG controls.
Selecting the on-screen TVG control will display the
TVG settings.
When connected to an external CHIRP sonar
modules (excluding DownVision
TM ) and external
Traditional sonar modules (excluding legacy) the
automatic TVG has 3 modes.
When in manual mode the slider bar control is
shown.
Enabling and disabling on-screen gain
controls
You can enable and disable the on-screen gain
controls by following the steps below.
On a touchscreen multifunction display, with the
relevant application displayed.
1. Select
Menu .
2. Select Presentation .
3. Select Gain Controls .
Selecting Gain Controls will switch between
showing and hiding the on-screen controls.
Note: When the on-screen Gain controls are set
to Hidden then the Gain settings can be accessed
directly from the application menu:
Menu > Gain .
Adjusting TVG manually using on-screen
controls
Touch only and HybridTouch multifunction displays
have on-screen TVG controls.
1. Select the on-screen
TVG control located on the
left hand side of the Fishfinder application.
2. Select the Auto box to switch between Auto and
Manual TVG.
3. Adjust the setting to the required value.
Setting auto TVG using the on-screen
controls
Touch only and HybridTouch multifunction displays
have on-screen TVG controls.
1. Select the on-screen
TVG control located on the
left hand side of the fishfinder application.
2. Select the Auto box to select Auto TVG mode.
3. When connected to external CHIRP sonar
modules (excluding DownVision TM ) and external
traditional sonar modules (excluding legacy) you
can select an auto TVG mode,
Noise Filter
The Noise Filter reduces the amount of clutter
displayed onscreen by varying the gain throughout
the column of water. Adjusting the setting can
improve target identification, however for optimum
performance in most conditions, it is recommended
that you use the auto setting.
The Noise Filter can be set to automatic or adjusted
manually:
• Automatic — In Auto mode the Noise Filter is set
to 20%.
• Manual — You can adjust the Noise Filter
manually, between a value of 0% to 100%.
– A low value decreases the depth at which the
filter is applied.
– A high value increases the depth at which the
filter is applied.
Sonar DownVision
0%
100%
The new values will persist over a power cycle.
Adjusting the Noise Filter
Follow the steps below to adjust the Noise Filter.
From the Fishfinder application:
1. Select
Menu .
2. Select Sensitivity Settings .
3. Select Noise Filter .
The Noise filter slider bar control is displayed.
4. Adjust the Noise Filter to the required value, or
5. Select the
Auto check box to switch to Auto
mode.
Note: The Noise filter can also be adjusted by
selecting the on-screen N. Filter control.
Color threshold
Color threshold determines the signal strength
below which targets are not shown. Traditional and
CHIRP sonar use different colors to determine signal
strengths whilst DownVision
TM uses monochrome
shading.
The Color Threshold setting is a global setting. When
the color threshold value is changed all Fishfinder
application panes on all networked multifunction
displays will share the same color threshold value.
274
gS Series