Lighthouse Raymarine gS 195, Инструкция по установке и эксплуатации

Страница: 271 / 440

20% Manual Gain Auto Gain 80% Manual Gain
Auto
In Auto mode the sonar module automatically adjusts
the gain setting to suit current conditions.
Auto Gain modes
When connected to a Legacy sonar module or a
Traditional internal sonar module 3 Auto Gain modes
are available:
• Cruising (Low)
• Trolling (Med)
• Fishing (Fast)
Auto Gain Offset
When connected to a CPx70 series sonar module
Auto Gain can be offset by +/–50%. This allows
small modification to be made to the gain, while
still utilizing Raymarine’s proprietary noise filter and
target identification algorithms.
Manual
If necessary you can set the gain controls manually,
between a value of 0% to 100%. This value should
be set high enough to see fish and bottom detail but
without too much background noise. Generally a
high gain is used in deep and/or clear water; a low
gain in shallow and/or murky water.
The new values remain set even when you switch
off the display.
Onscreen gain controls
Touch only and HybridTouch multifunction displays
have onscreen gain controls.
Selecting the gain control will display the gain
settings:
When connected to a Legacy
sonar module or a traditional
internal sonar module the
automatic gain has 3 modes.
When connected to external
CHIRP , external Traditional
or DownVision TM sonar
modules gain modes are not
provided.
When connected to a CPx70
series sonar module the Auto
gain can be offset by +/-50%
When in manual mode the
slider bar control is shown.
Note: SideVision TM channels do not use onscreen
Gain controls The Gain setting can be found in the
Sensitivity Settings menu.
Enabling and disabling on-screen gain
controls
You can enable and disable the on-screen gain
controls by following the steps below.
On a touchscreen multifunction display, with the
relevant application displayed.
1. Select
Menu .
2. Select Presentation .
3. Select Gain Controls .
Selecting Gain Controls will switch between
showing and hiding the on-screen controls.
Note: When the on-screen Gain controls are set
to Hidden then the Gain settings can be accessed
directly from the application menu:
Menu > Gain .
Adjusting gain manually using on-screen
controls
1. Select the on-screen Gain control located on the
left hand side of the fishfinder application.
2. Select the Auto box to switch between Auto and
Manual gain.
3. With Auto deselected, select and hold the Slider
and move Left to decrease value or Right to
increase value.
Setting the auto gain mode using the
on-screen controls
1. Select the on-screen Gain control located on the
left hand side of the fishfinder application.
2. Select the Auto box so that a tick is displayed
in the box.
3. Select the required Auto Gain Mode .
Adjusting fishfinder gain using the menu
The fishfinder gain setting can be accessed from the
fishfinder menu.
From the fishfinder application:
1. Select
Menu .
2. Select Sensitivity Settings .
3. Select Gain .
The Gain adjust dialog is displayed
4. Adjust the gain control to the required setting, or
5. Select
Auto .
A tick is displayed in the Auto box to signify
automatic gain is enabled.
Fishfinder application
271