Lighthouse Raymarine gS 195, Инструкция по установке и эксплуатации

Страница: 82 / 440

6.1 Switching the unit on and off
Powering the display on
1. Press the POWER button on the display.
2. Select Accept to acknowledge the disclaimer
message.
Putting the display into Standby
1. Press and hold the POWER button until the
countdown reaches zero.
If the POWER button is released before the
countdown reaches zero, normal operation is
resumed.
Standby mode allows the internal SeaTalk hs
network hub and PoE functions of the display
to remain active whilst all other functions are
powered off.
Refer to the Technical specification for details on
power consumption when in Standby mode.
Note: To completely power off the display so that it
is no longer consuming power the display must be
isolated from the power supply via the distribution
panel or breaker.
PowerSave mode
In PowerSave mode all functions of the multifunction
display remain active, but the unit is placed into a
low power state. PowerSave mode is automatically
cancelled when an alarm event occurs.
Note: To ensure user safety the PowerSave
feature will not be available if:
• any connected radars are switched on
• the multifunction display is providing autopilot
control in a system without a dedicated pilot
head and the autopilot is engaged.
Attention A gS Series MFD in PowerSave mode
will continue to consume some power from your
vessel’s batteries. The unit could drain your batteries
if left in PowerSave mode for prolonged periods of
time. When switching off the power to your vessel,
ensure that the unit is switched off at the power
distribution panel or breaker. For more information
on the amount of power consumed by the unit in
PowerSave mode, refer to
Chapter 31 Technical
specification .
Enabling PowerSave mode
To enable PowerSave mode follow the steps below.
1. Ensure any radars connected to the system are
switched off.
2. Press the POWER button.
The shortcuts menu is displayed.
3. Select PowerSave Mode .
The multifunction displays is now in PowerSave
mode.
4. You can wake the unit from PowerSave mode
at anytime by pressing the Power button or any
button on a connected keypad.
Note: PowerSave mode is automatically cancelled
if an alarm event occurs.
82
gS Series