Lighthouse Raymarine gS 195, Инструкция по установке и эксплуатации

Страница: 49 / 440

6. Vessel battery
7. Vessel RF ground point connection
Battery connection with no RF ground
If your vessel does not have a distribution panel
or an RF ground point then your product may be
wired directly to the battery with the drain wire also
connected to the battery’s negative terminal.
D13019-1
2 4 5 1 3
6
1. Vessel power supply positive (+)
2. Vessel power supply negative (-)
3. In-line fuse (If your products power cable does
not have a built in fuse then an in-line fuse
should be fitted.)
4. Drain wire connected to vessel negative power
supply.
5. Product power cable
6. Vessel battery
In-line fuse and thermal breaker ratings
The following in-line fuse and thermal breaker ratings
apply to your product:
In-line fuse rating Thermal breaker rating
15 A 15 A (if only connecting one
device)
Note:
• The suitable fuse rating for the thermal breaker
is dependent on the number of devices you are
connecting. If in doubt consult an authorized
Raymarine dealer.
• Your product’s power cable may have fitted
in-line fuse, if not then you can add an in-line
fuse to the positive wire of your products power
connection.
Sharing a breaker
Where more than 1 piece of equipment shares a
breaker you must provide protection for the individual
circuits. E.g. by connecting an in-line fuse for each
power circuit.
D11637-2
2
4 4
1
3
+
-
1
Positive (+) bar
2 Negative (-) bar
3 Circuit breaker
4 Fuse
Where possible, connect individual items of
equipment to individual circuit breakers. Where this
is not possible, use individual in-line fuses to provide
the necessary protection.
Touchscreen interference
In exceptional circumstances, due to the proximity
of certain electronic equipment that may be on the
vessel the touchscreen may become unresponsive
due to electrical interference.
In the unlikely event of this occurring the interference
can be suppressed by adding a grounding strap (not
supplied) to the rear case of the multifunction display.
The grounding strap should be connected to the
vessel’s RF ground point, or where no ground point
exists to the negative terminal of the vessel’s power
supply. The minimum recommended cable thickness
to be used for the grounding strap is 14AWG.
Note: On a gS95 the grounding points are the
same holes used for the mounting bracket securing
bolts.
The grounding strap should be fitted as shown below.
1 2
D
1
2
8
8
8
-1
Cables and connections 49