H3C XE 200 IP, Руководство по эксплуатации

Страница: 93 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-9
z
Specifying whether a gateway needs to perform authentication
z
Configuring the authentication password of a gateway
z
Configuring the bearer capability type for a gateway
I. Adding a gateway or entering a gateway view
If a specific gateway view already exists, you can enter it directly; if not, you must create
a new one first, and then enter it.
Perform the following configuration in LS view.
Table 1-9 Add a gateway or enter a gateway view
Operation Command
Add a gateway or enter a gateway view gateway device-id
Delete one or all gateways undo gateway { device-id | all }
Note:
In the actual network configuration, the IDs for all gateway(s), PS(s) and office device(s)
should be different.
II. Configuring the type of a gateway
There are two gateway types: H.323 and SIP. The voice-processing method varies with
the device type.
Perform the following configuration in LS-GW view.
Table 1-10 Configure the type of a gateway
Operation Command
Configure the type of a gateway device-type { h323 | sip }
Restore the default type undo device-type
III. Specifying whether a gateway uses a dynamic IP
If you specify a gateway as a dynamic IP device, the LS updates the IP address
dynamically with the latest one reported by the gateway when it registers with the LS,
otherwise the LS cannot update the IP address of the gateway dynamically.
Perform the following configuration in LS-GW view.