Operation Manual – Process Server Configuration
H3C XE 200/2000 IP PBX
Chapter 5 SIP Server Configuration
5-6
III. Tracing calls
Call trace is used to print the debugging information on the caller and callee related to a
number. The displayed debugging information spans levels 1 through 7. Before you can
use this function, you must enable debugging.
Perform the following configuration in PS view.
Table 5-12
Trace calls related to a number
Operation
Command
Trace calls related to the specified number
tracecall number
Cancel call tracing
undo tracecall
Note:
To start another call tracing, you must first use the
undo tracecall
command to cancel
the call tracing related to the existing number.
Before using the
tracecall
command, turn on the debugging information output display
switch with the
terminal debugging
command and the
terminal monitor
command.
IV. Automatically repairing TCP connection
Automatic TCP connection repair increases system robustness. It allows the system to
automatically attempt to repair a TCP connection that is disconnected for some
reasons.
Perform the following configuration in PS-SIP view.
Table 5-13
Automatically repair TCP connection
Operation
Command
Enable/disable automatic TCP
connection repair
repair-tcp
{
enable
|
disable
}
By default, TCP connection repair is enabled.
5.2 LS Configuration
5.2.1 Introduction to LS
A LS stores device information (about SIP devices, H.323 devices and office devices)
and numbers, and provides information when queried by the PS.
Содержание XE 200 IP
