H3C XE 200 IP, Руководство по эксплуатации

Страница: 113 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-29
Table 1-46 Configuring the priority of a static route number of an office group
Operation Command
Configure the priority of a static route
number of an office group
priority priority-level
Restore the default priority undo priority
II. Specifying whether to enable multiplexing
Use the multiplex command to specify the multiplexing mode of an office device
configured on an LS.
Perform the following configuration in LS-OFFICEGROUP-OFFICE view.
Table 1-47 Specify whether to enable multiplexing
Operation Command
Specify whether to enable multiplexing multiplex { disable | enable }
Restore the default setting undo multiplex
By default, multiplexing is disabled.
III. Configuring attribute of a static route number of an office group
For the attributes of a static route number, refer to Configuring attribute of a static route
number of a gateway .
Perform the following configuration in LS-LS-OFFICEGROUP-PREFIX view.
Table 1-48 Configure attribute of a static route number of an office group
Operation Command
Configure attribute of a static route
number of an office group
otapc { fxs | relay }
Restore the default attribute undo otapc
By default, the static route number is the user number.