H3C XE 200 IP, Руководство по эксплуатации

Страница: 17 / 514

Operation Manual – Basic Configuration
H3C XE 200/2000 IP PBX
Chapter 2 Command Line Interface for Configuration
2-7
Figure 2-10 Run the Telnet program
Step 3: Select [Connect\Remote system] in the Telnet window, and enter the IP address
of the Ethernet interface on the XE IP PBX in the dialog box as shown in Figure 2-11 .
Figure 2-11 Set up a Telnet connection with the XE IP PBX
Note:
Host Name in Figure 2-11 refers to the IP address of the XE IP PBX.
Step 4: After telnetting to the XE IP PBX, you are prompted for the username and
password. If the authentication is passed, the command line prompt (<XE> for example)
appears for you to configure the XE IP PBX or view its running status.
Note:
When you configure the XE IP PBX through telnet, be careful of modifying its IP
address as such modification may result in Telnet disconnection. If such modification is
required, you need to enter a new IP address of the IP BPX and make a new
connection.