H3C XE 200 IP, Руководство по эксплуатации

Страница: 416 / 514

Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 10 Call Forwarding Services
10-13
3) Configure service parameters on the XE IP PBX.
<XE>system-view
[XE]location-server
[XE-ls]gateway GW01
[XE-ls-gw-GW01]subscriber #1 8801
[XE-ls-gw-GW01 #1 8801]cfo
[XE-ls-gw-GW01 #1 8801-cfo]cfo-number 8803
[XE-ls-gw-GW01 #1 8801-cfo]quit
[XE-ls-gw-GW01 #1 8801]srv-switch cfo on
10.6 CFB Service
10.6.1 Introduction to CFB Service
With the CFB service, incoming calls are forwarded to the target number pre-specified
by the callee when the callee is busy. Calls will not be forwarded when the callee is idle.
Up to 2 CFB forward numbers can be set by the subscriber.
10.6.2 Using CFB Service
After the administrator enables the CFB service for a subscriber, target forwarding
numbers can be set by the following two methods.
z
The administrator can set the number on the XE through command lines. Refer to
10.6.3 “ Configuration Procedure ” for details.
z
The subscriber can set the number on the telephone set as follows.
I. Setting CFB target number on the telephone set
The following table describes the CFB target number setting task made by the
subscriber.
Table 10-14 Set CFB target number on the telephone set
Step Expected result
Pick up the phone. The subscriber can hear the dial tone.
Dial *40*, the target
forwarding number and # in
sequence.
If the setting succeeds, the subscriber can hear the
ringback tone or the voice prompt “You have
successfully activated the service.”
If the setting fails, the subscriber will hear the busy
tone or the voice prompt “Sorry, your attempt to
activate the service was unsuccessful.”
Hang up the phone. —