H3C XE 200 IP, Руководство по эксплуатации

Страница: 105 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-21
Table 1-30 Configure the transport layer protocol used by an office device
Operation Command
Configure the transport layer protocol
used by an office device
transport { auto | tcp | udp }
Restore the default transport mode undo transport
The parameter defaults to udp .
Note:
When configuring simultaneous ringing for multiple called parties, you must configure
the transport mode to tcp or udp using the transport command.
IX. Configuring default route number priority of the office device
If you have not configured route priorities for the number resource of the office device,
you can use the default priority of the current office device as the priority of number
resource.
Perform the following configuration in LS-OFFICEGROUP-OFFICE view.
Table 1-31 Configure default routing priority of the office device
Operation Command
Configure default routing priority of the
office device
priority priority-level
Restore the default priority undo priority
The default value of the routing priority of an office device is 10. The larger the value,
the higher the priority.
X. Configuring the status of an office device
The state of an office device can be forever or normal. In forever state, no heartbeat
message is exchanged between the PS and office device; while in normal state,
heartbeat messages (register messages based on SIP) are exchanged between them.
Perform the following configuration in LS-OFFICEGROUP-OFFICE view.