H3C XE 200 IP, Руководство по эксплуатации

Страница: 427 / 514

Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 12 ONLY Service
12-2
Note:
z
When configuring the ONLY number, make sure that it does not conflict with the
subscriber line number, the static route number, the automatic operator number and
the group notification number.
z
If you have configured and enabled the country code and area code on an XE IP
PBX, you should configure a full number for an emergency call number including the
country code and the area code.
z
The ONLY number must be a number already exists on the XE IP PBX.
12.3 Configuration Example
12.3.1 Configuration Requirements
The home, office 1, and office 2 numbers of subscriber A are 8801, 8802, and 8803
respectively. Subscriber ID 5678 is assigned when subscriber A applies for the ONLY
service. All the above numbers are bound to this ID.
I. Network Diagram
Note:
Refer to the network diagram in Network Diagram .
II. Configuration Procedure
1) Configure basic parameters on the XE IP PBX.
2) Configure basic parameters of gateways GW01, GW02, and GW03.
Note:
Refer to Configuration Example for the basic parameter settings.
3) Configure service parameters on the XE IP PBX.
# Create subscriber ID 5678.
[XE-ls]only 5678
# Bind the three numbers with the ID.
[XE-ls-only-5678]tel-number 8801