H3C XE 200 IP, Руководство по эксплуатации

Страница: 269 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX Chapter 2 Terminal Service and User
Interface Configuration
2-5
V. Setting data bits
Table 2-6 Set data bits
Operation Command
Set data bits databits { 5 | 6 | 7 | 8 }
Restore the default setting undo databits
The data bits available with an asynchronous interface are 5, 6, 7, and 8.
The data bits setting defaults to 8.
2.2.3 Configuring Terminal Attributes
Perform the following configuration in user interface view.
I. Enabling/disabling terminal service
Table 2-7 Enable/disable terminal service
Operation Command
Enable terminal service shell
Disable terminal service undo shell
Note:
z
By default, terminal service is enabled on all user interfaces.
z
Console user interface does not support the undo shell command.
II. Setting the idle-timeout timer
The connection to the user terminal is disconnected if it is idle for a period set by the
idle-timeout timer.
Table 2-8 Set the idle-timeout timer
Operation Command
Set the idle-timeout timer idle-timeout minutes [ seconds ]
Restore the default setting undo idle-timeout
By default, the idle-timeout timer is set to 10 minutes. When it expires, the terminal
connection is disconnected. Setting the timeout to 0 disables the timer and the
connection is maintained regardless of whether it is idle.