H3C XE 200 IP, Руководство по эксплуатации

Страница: 268 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX Chapter 2 Terminal Service and User
Interface Configuration
2-4
Note:
The speeds of 300 bps and 600 bps are supported only on XE 200 IP PBXs.
II. Configuring flow control mode
Table 2-3 Configure flow control mode
Operation Command
Configure flow control mode
flow-control { none | software |
hardware }
Restore the default flow control mode undo flow-control
The available flow control modes include:
none : No flow control.
software : Software flow control.
hardware : Hardware flow control, which is only applicable to the AUX port.
By default, the flow control mode of the terminal line is none , that is, no flow control.
III. Setting the parity bit
Table 2-4 Set the parity bit
Operation Command
Set the parity bit
parity { none | even | odd | mark |
space }
Restore the default parity setting
undo parity
The available parity options include: none , even , odd , mark , and space .
The parity defaults to none , that is, no parity check.
IV. Setting stop bits
Table 2-5 Set stop bits
Operation Command
Set stop bits stopbits { 1.5 | 1 | 2 }
Restore the default setting undo stopbits
The stop bits setting defaults to 1. XE 2000 IP PBXs only support the setting of stop bits
to 1 or 2.