H3C XE 200 IP, Руководство по эксплуатации

Страница: 102 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-18
Perform the following configuration in LS-OFFICEGROUP view.
Table 1-25 Configure the static route number of an office group
Operation Command
Configure the static route number of an office group prefix number
Delete one or all static route numbers of an office
group
undo prefix { number | all }
Note:
When configuring the static route number, make sure that it does not conflict with the
ONLY number, the automatic operator number and the group notification number. For
detailed information, refer to the “Call Services Operation” module of this manual.
Caution:
The XE IP PBX does not support cyclic route check.
For example:
z
On the LS A, map the static route number 8801 to the office PS B.
z
On the LS in the LS domain where the PS B resides, map the static route number
8801 to PS C.
z
On the LS in the LS domain where the PS C resides, map the static route number
8801 to PS D.
z
…
z
On the LS in the LS domain where the PS N-1 reside, map the static route number
8801 to PS N.
z
On the LS in the LS domain where the PS N resides, map the static route number
8801 to a certain PS in the LS A domain.
After the above configurations are completed, cyclic route will occur, thereby reducing
the network performance. Therefore, it is recommended not to perform such
configurations.
IV. Adding an office device or enter an office view
If a specific LS-OFFICE view already exists, you can enter it directly; if not, you must
create a new one first, and then enter it.
With the office command, you can enter office view of the specified office device, or
create the specified office if it does not exist and then enter its
LS-OFFICEGROUP-OFFICE view.