H3C XE 200 IP, Руководство по эксплуатации

Страница: 388 / 514

Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 6 Abbreviated Dialing Service
6-2
Configuration method Dialing method
Open abbreviated dialing.
Specify an abbreviated
number MN to represent
ABCD, part of the called
number ABCDEFGH.
Dial “**” plus MNEFGH.
6.1.2 Using Abbreviated Dialing Service
I. Configuring abbreviated dialing table
Follow the two methods below to set the abbreviated dialing table.
z
The administrator can configure the abbreviated dialing table on the XE IP PBX
through command lines. Refer to 6.2 “ Abbreviated Dialing Service Configuration ”.
z
The subscriber can configure the abbreviated dialing table on their telephone sets
as follows:
The following table describes how to add an abbreviated dialing item. If the specified
abbreviated number MN exists, the following operation will delete it and add a new
abbreviated number item.
Table 6-2 Add an abbreviated number item
Step Expected result
Pick up the phone. The subscriber can hear the dial tone.
Dial
*51*MN*ABCDEFGH#.
The subscriber can hear the ringback tone or the voice
prompt “You have already activated the service.”
If you fail, you will hear a busy tone or the voice prompt
“Sorry, your attempt to activate the service was
unsuccessful.”
Hang up the phone. —
Note:
To make services whose access codes include * or # work properly, you should not
specify on the gateway these two characters to act as dialing terminators.
The following table describes how to delete an abbreviated dialing item.