H3C XE 200 IP, Руководство по эксплуатации

Страница: 294 / 514

Operation Manual – System Management
H3C XE 200/2000 IP PBX
Chapter 4 System Maintenance and Management
4-12
IV. Module name
The module name field indicates which module sends the log information. You can view
the module list by executing the info-center source ? command in system view.
The module name and the severity level are separated by a slash (/).
V. Severity
Log information is sorted into eight levels identified with 0 through 7. See Table 4-8 .
The severity level and the digest are separated by a slash (/).
VI. Digest
Digest is a phase that abstracts the information.
The digest and the content are separated by a colon (:).
VII. Log host
You can set log hosts, up to four, for the system using the info-center loghost
command. By default, logs are sent to the log hosts through channel 2, that is, the
loghost channel.
You can set the source IP address in the log to the address of a fixed interface. This
allows log hosts to classify and manage log information by source address. For
example, you can use the info-center loghost source loopback0 command to set the
source address of the log information sent by the system to the address of the
loopback0 interface.
4.2.5 Displaying and Debugging Information Center
After completing the above configurations, you can perform the display command in
any view to verify the configuration, or execute the debugging command in user view
to debug the information center.
Table 4-14 Display and debug information about the information center
Operation Command
Display information about the information
center
display info-center
Display information about the log buffer display logbuffer [ size sizeval ]
Display information about the trap buffer display trapbuffer