H3C XE 200 IP, Руководство по эксплуатации

Страница: 104 / 514

Operation Manual – Location Server Configuration
H3C XE 200/2000 IP PBX
Chapter 1 Location Server Configuration
1-20
VII. Configuring the port number of an office device
Here, the port number of an office is a piece of information about the office recorded on
the LS. The LS sends voice call information through the port to the office device. You
must ensure that the port number configured on the LS for an office device must be
identical to the one configured on the office device.
Perform the following configuration in LS-OFFICEGROUP-OFFICE view.
Table 1-29 Configure the port number of an office device
Operation Command
Configure the port number of an office device port port
Restore the default port number undo port
By default, the port number of the office device is 5060.
Note:
If the type of the office device is SIP, you can keep this number unchanged; if the type
is h323-gk, you must use the port command to set the port number to 1719; if the type
is h323-gw, you must use the port command to set the port number to 1720.
VIII. Configuring the transport layer protocol used by an office device
Note:
This configuration does not apply to H.323 office devices.
The office device communicates with the PS using a certain transport mode. XE IP PBX
supports UDP and TCP transport modes. Three parameters are available: auto , tcp ,
and udp . In auto mode, TCP protocol is used first; if it fails, UDP protocol will be used.
As for tcp and udp modes, you must set a transport mode identical to the actual one. If
you have no idea how data are transported, you can set the mode to auto.
Perform the following configuration in LS-OFFICEGROUP-OFFICE view.