H3C XE 200 IP, Руководство по эксплуатации

Страница: 475 / 514

Operation Manual – Call Services
H3C XE 200/2000 IP PBX
Chapter 25
Number Query Service
25-1
Chapter 25 Number Query Service
25.1 Overview
25.1.1 Introduction to Number Query Service
With the number query service, a subscriber can dial the corresponding access code to
query its own number.
To use the number query service, you need to enable the MS on the XE IP PBX first.
Otherwise, a subscriber will hear the busy tone when attempting to use this service.
25.1.2 Configuring and Using Number Query Service
I. Working process of number query service
1) An authorized administrator logs on to the XE IP PBX and enables the number
query service for the subscriber. Refer to Number Query Service Configuration for
operation details.
2) The subscriber dials the access code *92#. Refer to Use number query service for
details.
3) The subscriber hears the voice prompt “Your number is XXXX ”.
II. Use number query service
Table 25-1 Use the number query service on the phone
Step Expected result
The subscriber picks up the
phone.
The subscriber hears the dial tone.
The subscriber dials *92#.
If the number query service is enabled for the
subscriber, the subscriber hears the voice
prompt “Your number is
XXXX. ”
If the native number query service is disabled
for the subscriber, the subscriber hears the
voice prompt “Sorry, the service is not
available.”
The subscriber hangs up. —