H3C XE 200 IP, Руководство по эксплуатации

Страница: 58 / 514

Operation Manual – Process Server Configuration
H3C XE 200/2000 IP PBX
Chapter 3 Gatekeeper Configuration
3-3
Table 3-4 Configure the identifier and interface of a PS
Operation Command
Configure the identifier of the PS and specify its
interface ps-config identifier interface
interface-type interface-number
Remove the basic configuration of the PS undo ps-config
V. Enabling/disabling a PS
Disabling/enabling a PS with the stop or start command is a software reset operation.
It will interrupt ongoing calls, disconnecting the PS from the LS and preventing it from
receiving messages from gateways. Then the PS reconnects with the LS for receiving
messages from gateways. (The gateway in this manual refers to H.323 gateway and
SIP user agent client, unless otherwise noted.)
Perform the following configuration in PS view.
Table 3-5 Enable/disable the PS
Operation Command
Enable the PS start
Disable the PS stop
Note:
Enabling (disabling) the PS enables (disables) the gatekeeper and SIP Server.
VI. Enabling/disabling long-time call interruption
This command is used to enable/disable long-time call interruption function. Each time
you use the function, a timer is enabled on the server which will break the conversation
when timeout interval expires on the timer.
Perform the following configuration in PS view.
Table 3-6 Enable/disable long-time call interruption
Operation Command
Enable long-time call interruption policy call-interrupt-by-long-time enable
Disable long-time call interruption policy call-interrupt-by-long-time disable