Eaton LMS, Руководство по установке, Страница: 161 / 202

C a b l e M a n a g e m e n t
A r m ( c o n t . )
3. Attach the Frame Bracket by either screwing it to the
Clip Nuts on the rack mount rails
OR by hooking it on-
to the slotted Full Frame. If the Bracket is being in-
stalled onto the Full Frame, it must be positioned as
close as possible to the roll-out surface. See
Figure 3 .
After the Frame Bracket has been installed, re-tighten
the two Phillips head adjustment screws.
4. The vertically oriented Plasic Cable Arm may be
attached to either the center, left side, or right side of the
roll-out. Roll-out shelves manufactured before June
1995 may not have the appropriate holes that are requir-
ed to mount the Cable Arm Bracket and may require
drilling.( Mark the appropriate hole locations for either
left, center, or right mounting on the rear flange of
the roll-out shelf and drill with a #9 [.166” dia.] drill bit.
Refer to
Figure 4 ).
5. Having determined your desired position, identify the
the appropriate two mounting holes in the Frame Bracket
that are in alignment with the desired mounting holes in
the back of the roll-out.
Install two Clip Nuts onto the Frame Bracket, orienting
them as shown in
Figure 5 .
Figure 3
Rack mount rail
Clip nuts
Adjustable frame
bracket
Slotted Full Frame
Adjustable frame
bracket
Roll-out surface
Figure 4
Rear view of roll-out
Figure 5
1.75” (1-3/4”)
Adjustable frame
bracket
Clip nut
Roll-out
Full Frame
83109
technical furniture
M-26