Eaton LMS, Руководство по установке, Страница: 136 / 202

1
Tools Required
- Plastic Mallet
1. Install the
Horizontal Cable Management
component(s) in the desired location on the back of
the frame by inserting the hooks at each end of the
component into the slots in the Slotted Standards.
See
Figure 1 .
The component should fall directly into place.To assure
that the hooks are properly seated, tap the top rear corn-
ers with a plastic mallet or equivalent. See
Figure 2 .
2. To remove the
Cover(s) from the Horizontal Cable
Management component(s), grasp the cover with both
hands and push down and rotate the bottom of the Cover
outward.
See Figure 3 .
NOTE : The 60” and 72” Horizontal Cable Management
components are provided with two piece covers
for ease of removal and/or installation.
3. Install the
Wire Retainers (provided) as shown in
Figure 4 .
4. To re-install the Cover(s), hook the top edge over the
top flanges of the Horizontal Cable Management. Push
down with both hands and rotate the Cover inward to
engage the bottom flanges of the Cable Management.
See
Figure 3 .
NOTE: If the Vertical Covers have been removed, re-install
them before installing the Horizontal Covers.
Horizontal Cable Management
Horizontal cable
management
Slotted standard
Figure 1
Upright
Horizontal cable
management component
Upright
Figure 2
Figure 3
Off
On
Cover
Figure 4
Wire retainer
Horizontal cable
management component
H o r i z o n t a l C a b l e
M a n a g e m e n t
81493
technical furniture
M-1