3 - 30
INSP
ADJ
REAR BRAKE PAD INSPECTION AND REPLACEMENT
• Remove the pad pin
6
and brake pads
7
.
• Connect the transparent hose
8
to the
bleed screw
9
and place the suitable con-
tainer under its end.
• Loosen the bleed screw and push the cali-
per piston in.
CAUTION:
Do not reuse the drained brake fluid.
• Tighten the bleed screw.
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
• Install the brake pad
0
and pad pin
A
.
NOTE:
• Install the brake pads with their projections
a
into the caliper recesses
b
.
• Temporarily tighten the pad pin at this
point.
• Install the caliper
B
and rear wheel
C
.
Refer to “FRONT WHEEL AND REAR
WHEEL” section in the CHAPTER 5.
• Tighten the pad pin
D
.
T
R
.
.
Pad pin:
18 Nm (1.8 m • kg, 13 ft • lb)
• Install the pad pin plug
E
and protector
F
.
T
R
.
.
Pad pin plug:
3 Nm (0.3 m • kg, 2.2 ft • lb)
Bolt (protector):
7 Nm (0.7 m • kg, 5.1 ft • lb)
