5 - 44
CHAS
HANDLEBAR
10. Install:
• Start switch
1
• Master cylinder
2
• Master cylinder bracket
3
• Bolt (master cylinder bracket)
4
• Clamp
5
NOTE:
• The start switch and master cylinder bracket
should be installed according to the dimen-
sions shown.
• Install the bracket so that the arrow mark
a
faces upward.
• First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the
bolt on the lower side.
T
R
.
.
9 Nm (0.9 m · kg, 6.5 ft · lb)
Zero mm
(Zero in)
Zero mm
(Zero in)
11. Install:
• “ENGINE STOP” button
1
• Clutch lever holder
2
• Bolt (clutch lever holder)
3
• Hot starter lever holder
4
• Bolt (hot starter lever holder)
5
• Clamp
6
NOTE:
• The “ENGINE STOP” button, clutch lever
holder and clamp should be installed accord-
ing to the dimensions shown.
• Pass the “ENGINE STOP” button lead in the
middle of the clutch lever holder.
T
R
.
.
4 Nm (0.4 m · kg, 2.9 ft · lb)
T
R
.
.
4 Nm (0.4 m · kg, 2.9 ft · lb)
12. Install:
• Clutch cable
1
• Hot starter cable
2
NOTE:
Apply the lithium soap base grease on the
clutch cable end and hot starter cable end.
