Woodward HighPROtec MCDLV4, Manual

Page: 1217 / 1275

General Lists
Name Description
Profibus.Data OK Data within the Input field are OK (Yes=1)
Profibus.SubModul Err Assignable Signal, Failure in Sub-Module, Communication Failure.
Profibus.Connection
active
Connection active
Profibus.Scada Cmd 1 Scada Command
Profibus.Scada Cmd 2 Scada Command
Profibus.Scada Cmd 3 Scada Command
Profibus.Scada Cmd 4 Scada Command
Profibus.Scada Cmd 5 Scada Command
Profibus.Scada Cmd 6 Scada Command
Profibus.Scada Cmd 7 Scada Command
Profibus.Scada Cmd 8 Scada Command
Profibus.Scada Cmd 9 Scada Command
Profibus.Scada Cmd 10 Scada Command
Profibus.Scada Cmd 11 Scada Command
Profibus.Scada Cmd 12 Scada Command
Profibus.Scada Cmd 13 Scada Command
Profibus.Scada Cmd 14 Scada Command
Profibus.Scada Cmd 15 Scada Command
Profibus.Scada Cmd 16 Scada Command
ProtCom.active Signal: active
ProtCom.inactive Signal: inactive
ProtCom.ExBlo Signal: External Blocking
ProtCom.Blo forced Protection-communication is temporarily forced to be deactivated (blocked).
ProtCom.Qual.Warn. Error Rate is above warning level.
ProtCom.Comm.Ok Protection-communication Ok. Measuring systems is synchron with remote device.
ProtCom.FrameSync Frames are synchronized.
ProtCom.TimeSync Internal time bases are synchronized.
ProtCom.Loopback Device is in Loopback-mode.
ProtCom.ExBlo1-I Module input state: External blocking1
ProtCom.ExBlo2-I Module input state: External blocking2
IRIG-B.IRIG-B active Signal: If there is no valid IRIG-B signal for 60 sec, IRIG-B is regarded as inactive.
IRIG-B.High-Low Invert Signal: The High and Low signals of the IRIG-B are inverted. This does NOT mean that
the wiring is faulty. If the wiring is faulty no IRIG-B signal will be detected.
IRIG-B.Control Signal1 Signal: IRIG-B Control Signal. The external IRIG-B generator can set these signals.
They can be used for further control procedures inside the device (e.g. logic
funtions).
IRIG-B.Control Signal2 Signal: IRIG-B Control Signal. The external IRIG-B generator can set these signals.
They can be used for further control procedures inside the device (e.g. logic
funtions).
1217 MCDLV4 DOK-HB-MCDLV4-2E