Welch Allyn Connex IWS, Directions For Use Manual

Page: 55 / 266

2. If your wall system is configured for SpO2 (or SpHb), attach the spool to the
accessory bin by sliding the spool onto the retention clip.
3. Properly orient and insert the sensor cable into the patient cable connector. (You just
connected the opposite end of the sensor cable to the wall system.) Ensure the
sensor cable is inserted completely, then close the protective cover. (See the sensor
manufacturer's directions for use.)
4. Wrap the excess patient cable around the spool, and place the finger clip in the
holder. Also observe the maximum safe working load limit noted here when filling
the bin.
Directions for use Setup 49