Welch Allyn Connex IWS, Directions For Use Manual

Page: 111 / 266

Icons in the Device Status area
Icon Name and status
Multiple alarms toggle.
Touch this icon to cycle through the messages for each active alarm.
Alarm audio paused.
The audio tone is paused. The icon remains until the paused time counts down to 0. Touch this
icon to start the user-configured pause interval (set in the Advanced tab).
Patient rest mode
Patient rest mode enables you to turn the audio off and dim the screen of the device
when continuous monitoring is enabled and a device is connected to the central station.
The visual alarms indication on the device will display, and audible alarms will sound at a
compatible Welch Allyn host with visual indications. The device may still be used for
additional vitals capture. Touch the screen to remove the dimming while in use. If a loss
of connectivity occurs, certain alarms become audible until connectivity is restored.
Patient rest mode can be enabled and disabled from the central station or from the
device.
Patient rest mode location on the monitor
Access the rest mode on the Alarms tab.
CAUTION Loss of power will cause the monitor to return to default
settings. Each time you power up the monitor, you must set alarm limits
appropriate for your patient.
Turn on patient rest mode
To turn on the patient rest mode from the device:
1. Touch the Alarms tab.
The Alarms screen appears.
2. On the Alarms screen, touch Patient rest mode on .
The patient rest mode is activated.
Turn off patient rest mode
To turn off the patient rest mode from the device:
1. Touch the Alarms tab.
The Alarms screen appears.
2. On the Alarms screen, touch either Alarm audio on or Alarm audio off .
The patient rest mode is deactivated.
Directions for use Alarms 105