Sewing a test seam by using the Straight Stitch - Centre 00 as an example
Sewing a test seam
79
Manual • Sewing machine W6 N 2000 Exklusive W6 N 2000 Exklusive • 27/04/2018 • 1.0 • GBR
4.
Use one hand to hold the thread and fabric firmly.
!
The edge of the fabric should lie 3 to 5 stitches behind the first
needle entry point. In this way, the sewing machine cannot stitch
itself down at the beginning of the fabric.
5.
To back tack at the beginning of the seam, press the
‹Reverse button›
and maintain this position for two or three back-tacks.
6.
Start the machine with the
‹foot controller›
and using the
straight
stitch
, sew forwards.
!
Alternatively, you can also sew without the foot controller. Start and
stop the sewing machine by means of the ‹Start-Stop› button.
7.
Approximately 1 cm before reaching the end of the seam, press the
‹Re-
verse button›
to back tack and maintain this position for two or three
back-tacks.
8.
Lift the
‹presser foot lifter›
.
9.
Pull the fabric out carefully and cut off the upper and lower threads.
»
The test seam has been sewn
W6 Tip
Adjust the stitch length to the various types of fabric. In general, the thicker
the fabric to be sewn, the greater the stitch length that must be selected.
