VeEX RXT-6000e, User Manual

Page: 273 / 387

Multiple Streams - MAC/IP Address Setup
If all of the streams are going to the same far-end unit, then the MAC/IP destination
addresses must be the same on all of the streams.
If any of the traffic streams are going to more than one far-end unit then ensure the
correct MAC/IP destination addresses are configured for the respective streams.
Go back to top Go back to TOC
13.5.1.4 Traffic Settings (Per Stream Configuration)
In the Traffic tab the user is able to configure the traffic profile per stream, including frame size selection, traffic type,
and transmit rate.
Stream #:
Select a stream number to configure.
Traffic Flow: Select from Constant, Ramp, Burst, or Single Burst traffic flow.
Frame Size (Type):
Fixed or Uniform. If uniform is chosen, the user will have to input a minimum and
maximum frame size.
Frame Size (bytes): If a fixed frame size is chosen, this option is enabled. Enter the frame size when a Layer 2
or 3 is selected. Frame sizes can be from 64bytes to 1518bytes, in addition to jumbo frames up to 10k bytes.
BW (Transmit Bandwidth):
Configure the transmit rate for the stream.
The bandwidth allocation per stream is already configured in the General Settings tab, but can be modified
in this screen as well.
For more information on Traffic Settings, please see 13.2.1.2 BERT Traffic Settings .
Throughput Setup - Traffic Setup - Constant Traffic Flow
RXT-6200_RXT6000e_Module_Manual Page 273 of 387