VeEX RXT-6000e, User Manual

Page: 298 / 387

Y.1731 Performance Management Functions
OAM - Service Level OAM (Page 3)
Loss (LMM/LMR) and Delay Measurement (DMM/DMR) Configuration Parameters
Destination
MEP
: Sends LMM/DMM to the destination MEP as configured on Page 1
MAC : Sends LMM/DMM to a destination MAC address
Priority
- 802.1p priority in the LMM/DMM VLAN Tag
Destination MAC - Configure the destination MAC address used for the LMM/DMM. This field is only used if
Destination is set to MAC. If destination is set to MEP, this field is ignored.
# Send - Configure the number of LMM/DMM frames to send up to 50
Rate :
Configure the LMM/DMM frame interface rate (min: 100 ms; max: 10 seconds)
Press Start to initiate testing.
Frame Loss Measurement
Two local counters for each peer MEP:
TxFCf: Counter for in-profile data frames transmitted towards peer MEP
RxFCf: Counter for in-profile data frames received from peer MEP
Single-ended ETH-LM:
On demand OAM
MEP sends LMM frame (Unicast DA or Multicast Class 1 DA) and receives LMR frame (Unicast DA) with counters
CCM frames contain frame counters.
Single Ended Frame Delay Measurement
RXT-6200_RXT6000e_Module_Manual Page 298 of 387