VeEX RXT-6000e, User Manual

Page: 354 / 387

Go back to top Go back to TOC
MAC, VLAN, MPLS, IP, UDP, eCPRI, DATA, and RX Filter Test Pattern Configurations:
To configure the MAC addresses, IP addresses, VLAN tag(s), and test pattern, tap on the frame image displayed on the screen.
This brings up the configuration screens for all the header fields.
Tap the Apply button at the bottom to save your selections to the current stream or Apply to All to save your selections to all
streams.
MAC Header Tab:
MAC Source: Use the default source address of the test set or configure a new or different address.
Tap the Mac Source button at the bottom to populate the fields with default test port settings.
For Layer 4 (IPv6) only: Tap the NDP Gateway and NDP buttons at the bottom to locate MAC addresses on the local
network for the network address designated in the gateway.
MAC Destination : Configure the destination MAC address of the far-end partner test set.
Ethernet Type:
Layer 2: AE-FE (fixed)
Layer 4 : Set to 0800-IP (fixed), or
select 8847-MPLS unicast or 8848-MPLS multicast if MPLS tagging is enabled.
Throughput Setup - MAC Layer 4
Go back to top Go back to TOC
VLAN Tab:
VLAN ID: Configurable in the range 1 to 4094.
Identifies the VLAN; used by standard 802.1Q.
It has 12 bits which allows the identification of 4096 (2^12) VLANs.
Of the 4096 possible VIDs, a VID of 0 is used to identify priority frames and value 4095 (FFF) is reserved.
Maximum possible VLAN configurations are therefore set to 4094.
VLAN Priority: Configurable in the range 0 to 6
RXT-6200_RXT6000e_Module_Manual Page 354 of 387