VeEX RXT-6000e, User Manual

Page: 360 / 387

RX Filter Tab: Filters incoming streams. When checked, the incoming traffic flows that do not match these criterion will not
be considered for test results.
MAC Destination
MAC Source
VLAN
Ethernet Type
DSCP (Layer 4 only)
Protocol Type (Layer 4 only)
IP Destination (Layer 4 only)
IP Source (Layer 4 only)
Destination Port (Layer 4 only)
Source Port (Layer 4 only)
VLAN Eligible (Layer 4 only)
Throughput Setup - RX Filter Header Setup Settings Layer 4
Go back to top Go back to TOC
17.4.1.2 Traffic Settings (Per Stream Configuration)
Use the Traffic tab to configure the traffic profile per stream, including frame size selection, traffic type, and transmit rate.
Stream #: Select a stream number to configure.
Traffic Flow:
Multiple Streams: Constant
Single Stream: Ramp, Burst, or Single Burst
Frame Size (Type): Fixed
Frame Size (bytes): If a fixed frame size is chosen, this option is enabled to enter the frame size. Frame sizes can be from
64 bytes to 1518 bytes, in addition to jumbo frames up to 9k bytes.
Constant Bandwidth: Configure the transmit rate for the stream. The parameters depend on the Traffic Flow selected.
Constant Traffic Flow: Constant Bandwidth
Ramp: Start BW, Stop BW, Step BW, Ramp Time, Repetitions
Burst: Burst 1 Bandwidth, Burst 1 Time, Burst 2 Bandwidth, Burst 2 Times
Single Burst: Single Burst Bandwidth
The bandwidth allocation per stream is already configured in the General Settings tab, but can be modified in this screen as
well.
Throughput Traffic Settings
RXT-6200_RXT6000e_Module_Manual Page 360 of 387