Taiden hcs-8300, Installation And Operation Manual

Page: 55 / 255

42
external audio device; and you can connect an
external audio mixer between LineIn2 and
LineOut;

Sync. Line Out1 Mixer: Adjust the audio
parameters (Conference Management System -
Setup - Audio Output Setup) of LineOut1 and the
floor signal via Mixer 1 synchronously, see figure
2.1.12. This mode is used in the conference
room without PA.
In the three modes above, if ambient microphone
(used to pick up ambient sound in the congress
room) is enabled via software (Conference
Management System - Setup - Ambient Mic. Setup)
and this microphone is active, its signal is added to
the floor signal only. When any one microphone is
activated, the ambient microphone will be turned
off automatically.
b). Press the “MENU” button to save and return to the
upper level menu.
41. Lock CU LCD Lang. Setting
a). Press the “

/

” button to select “Yes” or “No”;

If select “ Yes ”, operation language of congress
unit (excl. Paperless Multimedia Congress
Terminal) and interpreter unit cannot be
changed;

If select “ No ”, operation language of congress
unit (excl. Paperless Multimedia Congress
Terminal) and interpreter unit can be changed;
b). Press the “MENU” button to save and return to the
upper level menu.
42. Nameplates setting
Select turn on the HCS-1030 electronic nameplate or
not which is not assigned delegate unit.
a). Press the “

/

” button to select “Turn Off” or “Turn
On”;
b). Press the “MENU” button to save and return to the
upper level menu.
43. DDS Units Setting
Set work mode for HCS-XXXXDDS:
a). Press the “

/

” button to select “Turn Off” or “Turn
On”;

Single ID: one HCS-XXXXDDS owns one ID
and dual predefined positions; two delegates
may share one unit;

Double ID: one HCS-XXXXDDS owns double
IDs and each predefined position for each ID;
two delegates may share one unit;
b). Press the “MENU” button to save and return to the
upper level menu.
44. Retractable Mic. Setting
Control the array microphone of HCS-4851/50 series
retractable microphone.
a). Press the “

/

” button to select “Control” or “Sync
Number”;

If select “ Control ”, use the “MENU” button to go
to step b);

If select “ Sync Number ”, use the “MENU” button
to go to step c);
b). Press the “

/

” button to select “Retract” or
“Raise”;
c). Press the “

/

” button to set sync number from 1
to 6;
d). Press the “MENU” button to confirm the operation
and return to the upper level menu.
Note:

Please restart the CMU to enable the DDS
units setting.