Taiden hcs-8300, Installation And Operation Manual

Page: 43 / 255

30

Unit Status
When entering this submenu, a table consisting of the
total number, active number, and request-to-speak
number of microphones is shown as in the following
figure.

Interpretation Status
Monitors the language channels and their states. Only
8 language channels’ status can be displayed in one
full screen. All channels can be run through by the
“

/

” button.
The “F” stands for the original floor language. If the
microphone of the Interpreter unit in the booth is active,
the “+” will replace the “F” at the associated language
channel, however, if all microphones in the booth are
switched off, the “+” will return to the “F” again.
Press the “MENU” button to view the channel state. If a
channel hasn't been allocated to an interpretation
booth or if it has not been fed with language output
temporarily, the LED displays as in the following figure:
If the microphone of the Interpreter unit in the booth is
active, the audio parameters of the Interpreter unit will
be displayed as in the following figure and can be
adjusted:
Under channel state interface, press the “MENU”
button to select the channel number or parameter and
press the “

/

” button to change the channel number
or parameter.
2.1.4.4 Test
“Test” cannot work under “VOICE” and “PTT” mode, its
submenu includes:
“Microphone” “LCD”
“Button” “Loudspeaker”
“LED”
1. Microphone
Testing microphones before the meeting. This interface
is inaccessible if no unit is connected.

The “

/

” button is used to run trough all
connected contribution units;

The “MENU” button is used to switch the unit
ON/OFF to check if it can be turned ON/OFF
normally or not;

After finishing the run, quit the interface by pressing
the “

” or the “EXIT” button.
2. LCD
a). Press the “

/

” button to select “LCD” and press
the “MENU” button to enter LCD test interface.
Column scan will be executed immediately to scan
the first column, shown as in the following figure:
b). When the first time column scan is finished, press
any button to start the second time column scan;
c). When the second time column scan is finished,
press any button to start the first time line scan,
shown as in the following figure;
d). When the first time line scan is finished, press any
button to start the second time line scan;