Taiden hcs-8300, Installation And Operation Manual

Page: 211 / 255

198
6.9.3 Configuration and operation
After installation, power on the HCS-8301 series digital
audio mixer, initialization interface will show as in the
following figure:
After initialization, it will display current status, as in the
following figure:
The connection status of the mixer will be displayed at
the lower right corner:
stands for disconnected;
stands for connected;
“M” stands for connected to main unit;
“S” stands for connected to backup main unit.
The current state of each channel corresponds to the
configuration of the control panel; click the “
”
button
or the “
”
button to browse the status of all
SI channels.
Click the “
”
button to enter configuration interface:

Machine Name
Input machine name through the virtual keyboard.

Enable/Disable "OFF" button
If enabled, pressing the “OFF” button will turn off
corresponding channel.

Disables display of SI channel 0
If select this item, the information of simultaneous
interpretation channel 0 (Floor channel) will not be
displayed on the LCD screen.

Network
Mixer IP Address: IP address of the mixer;
Mixer Subnet Mask: subnet mask of the mixer;
Host IP Address: IP address of the main unit;
Host IP Backup Address: IP address of the backup
main unit

Click the parameter which you want to modify;

Use numeric keypad buttons to setup;

Use “
←
” to delete a digit;

Use “OK” to save settings.

Brightness
Adjust brightness by pressing the “ ” or the “ ”
button.

Screen calibration
If the touch buttons do not react properly when pressed,
the panel should be calibrated again.
Press the “Calibrate” button to enter the calibration
window of the touch panel.
Please click the crosshairs to achieve calibration, repeat
as the cursor moves around the screen.