Taiden hcs-8300, Installation And Operation Manual

Page: 53 / 255

40
a). Press the “

/

” button to select “Yes” or “No”;

If “Yes” is selected, force handheld microphone
to PTT mode;

If “No” is selected, handheld microphone works
the same as the stem microphone;
b). Press the “MENU” button to save and return to
upper level menu.
32. Extension Port Setting
Enable/disable extension port on the backside of the
CMU.
a). Press the “

/

” button to select “Yes” or “No”;
b). Press the “MENU” button to save and return to
upper level menu.
33. Fiber Port Setting
Enable/disable fiber port on the backside of the CMU.
a). Press the “

/

” button to select “Yes” or “No”;
b). Press the “MENU” button to save and return to
upper level menu.
34. CobraNet Bundle Setting
Setup Cobranet Tx and Rx bundle.
(HCS-8300MAU/FS)
a). Press the “

/

” button to select Tx bundle or Rx
bundle;
b). Press the “MENU” to confirm;
c). Press the “

/

” button to set port number (press
and hold the “

/

” button will adjust numeric value
quickly);
d). Press the “EXIT” to save and return to the upper
level menu.
34. CobraNet/Dante Output Setting
Enable/disable cobranet/dante output of the CMU.
(HCS-8300MAU/FS)
(HCS-8300MAD/FS/20)
a). Press the “

/

” button to select “Disable” or
“Enable”;
b). Press the “MENU” button to save and return to the
upper level menu.
35. Single Mic Output Mode
Set up single microphone output mode.
a). Press the “

/

” button to select “On” or “Off”,
When selected “On”, microphone 1~6 was
transmitted to group out 1~6 respectively. It is used
for microphone recording, and under this mode, the
mixer and group out volume adjusting are
unavailable;
b). Press the “MENU” button to save and return to the
upper level menu.
36. Conference Room Setting
This function is used for conference room combination
and interpreter booth sharing.
a). Press the “

/

” button to set conference room ID,
the maximum number is 1000;
b). Press the “MENU” button to set conference room
name, the maximum length is 16 characters;

Press the “MENU” button to enter the name
setting interface, the cursor blinks under the first
character;