Taiden hcs-8300, Installation And Operation Manual

Page: 163 / 255

150
According to the requirements of the specific case in this
section, the configuration is as the following:
1. Configuration CMU
a) Active microphone number limitation: active
microphone number limitation limited to 2 implies
that at most two microphones can be turned on.
Chairman unit and VIP are not restricted and do not
count in this limitation.
b) Speech mode: speech mode is set to “Open”, none
other delegate can turn on his/her microphone if
the current speaker does not turn off his/her
microphone.
c) Simultaneous interpretation - language channel
configuration: Assuming that three languages are
used by the delegates, including Chinese, English
and French, meaning that three kinds of language
channels are needed, respectively, set channel
1–Chinese, channel 2-English and channel
3-French.
d) Simultaneous interpretation – booth number
configuration: The booth number is set as 2.
Translation between English-Chinese and
French-Chinese respectively.
e) Simultaneous interpretation - output channel
configuration: The output channel A of booth 1 is
English, output channel C is “No output” and output
channel B is “All channels”, and two Interpreter
units are equipped. The output channel A of booth
2 is French, output channel B and C is “No output”,
and two Interpreter units are equipped.
f) Simultaneous interpretation – auto-relay booth
configuration:

booth #1: no auto-relay booth

booth #2: set auto relay booth number as 1,
meaning that booth #1 is the auto-relay booth
for booth #2. When booth #1 uses output
channel B, booth #2 will go to auto-relay
status automatically and auto-relay
interpretation will be achieved.
g) Chairman priority mode is set as “All mute”.
2. Configurate Interpreter units in booth 1 (the
configuration of both Interpreter units is the same)
a) Channel B output: pressing output channel B switch
and rotating Primary knob at the same time, and set
Chinese as channel B output language.
b) Booth number is set to 1.
c) Preset monitoring channel. Channel a, b, c are set
as 1-Chinese, 2-English and 3-French respectively.
3. Configurate Interpreter units in booth 2 (the
configuration of both Interpreter units is the same)
a) Channel B output does not need to be setup
(because output channel B of booth 2 is set as “No
output” in CMU configuration).
b) Booth number is set to 2.
c) Preset monitoring channel. Channel a, b, c are set
as 1-Chinese, 2-English and 3-French respectively.
4. Volume control
Turn on delegate/chairman unit and adjust the volume of
the built-in loudspeaker on the congress units to suitable
volume.
5. Finish configuration, and the system can work
now.