Siemens SINUMERIK, Commissioning Manual

Page: 163 / 736

Diagnostics and service
5.6 Action log
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
157
Zero-Offset Shift Fine Mirror Rotation Factor
ACTFRAME 24.000000 22.300000 0 0.000000 1.000000
IFRAME 56.000000 3.300000 0 0.000000 1.000000
PFRAME 4398.000000 34.340000 0 0.000000 1.000000
EXTFRAME 0.000000 0.000000 0 0.000000 1.000000
TOTFRAME 0.000000 0.000000 0 0.000000 1.000000
ACTBFRAME 0.000000 0.000000 0 0.000000 1.000000
SETFRAME 12.000000 0.300000 0 0.000000 1.000000
EXTSFRAME 33.000000 2.300000 0 0.000000 1.000000
PARTFRAME 4354.000000 34.000000 0 0.000000 1.000000
TOOLFRAME 0.000000 0.000000 0 0.000000 1.000000
MEASFRAME 0.000000 0.000000 0 0.000000 1.000000
WPFRAME 0.000000 0.000000 0 0.000000 1.000000
Additional information on "State" and "Index" is provided in:
References: HMI Programming Package, Part 1 Operator's Guide → "Sequence control"
5.6.3 How to save the log file
Requirements
The actual log file is displayed in the operator area "Diagnostics" → "Service Displays" →
"Action Log" on the screen (softkeys "MMCWIN file" and "Crash Log").
Log file after initiating the trigger
The file CRASH.COM is generated in the following cases:
●
If the interface signal DB19.DBX0.6 "Save action log" changes from 0 to 1.
● If the alarm entered in field "Write trigger via alarms" occurs.
The PLC must set and reset the bit at the user interface (in the same way as the key lock
and screensaver control, for example). HMI-Advanced evaluates the rising edge of the signal
(i.e. a transition from 0 to 1) and creates the log file when the signal arrives. HMI-Advanced
only read-accesses the data, i.e. the user must reset the signal in the PLC program.
If the bit is already set when the HMI starts up, HMI-Advanced does not respond to the value
of the bit (until it is reset and set again).