Siemens SINUMERIK, Commissioning Manual

Page: 295 / 736

List of the INI Files
A.11 IB.INI
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
289
[LANGUAGE]
;Softkey "select language" instead of softkey "change language"
; in the main menu of area setup.
;False: Softkey "change language" to toggle between the foreground and background
language.
;True: Softkey "select language" instead of softkey "change language"
;to select one of the installed languages. To use this add the following values
;to the entries of the LANGUAGE section in the mmc.ini:
;LanguageList= ... , GR
;FontList= ... , Europe
;FontListKO= ... , Europe2
;LBList= ... , German
SkSelectLngInsteadSkChangeLng=False
[Softkeys]
; Softkey "Advanced Reset..." 0 = not visible ; 1 = visible
AdvancedReset = 0
; LockResetIfPulsesEnabled = 0 → Reset is possible although pulses are enabled
; LockResetIfPulsesEnabled = 1 → Reset is not possible if pulses are enabled
LockResetIfPulsesEnabled = 0
[Reset]
ResetWith_p0972 = true
Meaning of the parameters
The parameters in the [SOFTKEYS] section have the following meaning:
●
AdvancedReset:
If the value is 1, the "Advanced Reset" softkey will be displayed in the Reset menu. This
enables the NCK and drives to be reset separately. (Default setting: = 0)
● LockResetIfPulsesEnabled:
If the value is 1 and the drives are in closed-loop control, a reset cannot be triggered.
Enables must be removed manually.
● ResetWith_p0972:
With Sinamics versions V2.5 SP1 and higher or V1.5 SP1 and higher, all control units are
reset with p0972=3 during an NCK reset (hardware reset when cyclic communication
fails). The same reset is also triggered after standard commissioning and factory settings
have been loaded.
The default setting is ResetWith_p0972 = true.