4 Determining IP Addresses
4-8
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User’s Manual (W563)
Connect the Sysmac Studio online to the Controller.
The Controller and the computer that runs Sysmac Studio are connected as shown below via USB or
Ethernet:
Ethernet Connection
Connection from USB Across Ethernet
Additional Information
•
Auto IP automatically assigns IP addresses in Windows 98 and later operating systems.
Unique IP addresses are automatically assigned from the address 169.254.0.0 to
169.254.255.255.
•
If the IP address of the connected EtherNet/IP port is changed when the Sysmac Studio is
connected online via a built-in EtherNet/IP port, a timeout will occur in the Sysmac Studio. In
the case, switch the Sysmac Studio status to offline, change to the IP address of the con-
nected built-in EtherNet/IP port, and then switch back the Sysmac Studio status to online. This
will allow you to reconnect.
4-2-3
Online Connection
Types of Connections between the Controller and Computer That
Runs the Sysmac Studio
Direct Connection via Ethernet (1:1 Connection
with AutoIP)
Ethernet Connection via Hub (1: N Connection)
Note 1
An Ethernet switch is not necessarily required.
2
You can use a straight or cross Ethernet cable
to connect.
Note
An Ethernet switch is required to connect. Refer
to
2-1-4 Precautions for Ethernet Switch Selec-
for details.
Remote Connection via USB (1:N Connection)
Note 1
An NJ/NX-series Controller with a USB port is
required to connect.
2
An Ethernet switch is required to connect. Refer to
2-1-4 Precautions for Ethernet Switch Selection
for
details.
Ethernet
Ethernet
Ethernet
USB
Summary of Contents for Sysmac NY512-1300
Page 459: ......
