5-5
5 Sysmac Studio Settings for the Built-in EtherNet/IP Port
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User’s Manual (W563)
5-1 T
C
P/IP Setting
s Displa
y
5
Port Forward
Packet Filter
*1 By default, only the reception of IP packets transmitted from a network to which the internal port belongs (on
the Windows side) is permitted.
*2 Specify the IP address by setting the items IP address and Subnet mask.
*3 This indicates a network to which the IP address for the internal port belongs. Unlike IP address specification,
you do not need to change this setting even if you change the IP address for the internal port after setting this.
*4 You need to set this item only if you set Specification method to IP address specification.
Setting
Description
Default
IP Forward
Specify whether to relay IP packets between the built-in Ether-
Net/IP port and the internal port on the Controller.
Use
NAT
Specify whether to convert the source IP address to the IP
address for the built-in EtherNet/IP port if packets from Windows
are relayed via the internal port to a network on the built-in Ether-
Net/IP port side.
Use
Setting
Description
Default
Packet Filter
Specify whether to set conditions for the IP packets received by the
internal port.
Use
*1
Pass Frame
Specify the conditions for the IP packets permitted to be received
by the internal port by setting the items shown below. You can set a
maximum of 32 conditions for the IP packets permitted to be
received.
This setting is valid only if you set
Packet Filter
to
Use
.
---
Specification
method
Select from the following the specification method for the IP pack-
ets permitted to be received.
•
IP address specification
*2
•
any
•
Interface network
*3
Interface net-
work
IP address
*4
Set the IP address for which you permit reception.
None
Subnet mask
*4
Set the subnet mask for which you permit reception.
None
Protocol
Select
any
,
tcp
,
udp
,
igmp
, or
icmp
.
any
Range specifica-
tion
If you set
Protocol
to
tcp
or
udp
, specify whether to set a range of
port numbers for which you permit reception.
•
Selected
Range specification is enabled. Specify a range by setting the
items
Port
A
and
Port
B
.
•
No check
Range specification is disabled. Set an individual port number in
the item
Port A
.
No check
Port A
Set the starting IP address of the range for which you permit recep-
tion.
None
Port B
Set the ending IP address of the range for which you permit recep-
tion. You need to set this only if you selected
Range specification
.
None
Summary of Contents for Sysmac NY512-1300
Page 459: ......
