12-21
12 SNMP Agent
NY-series Industrial Panel PC / Industrial Box PC Built-in EtherNet/IP Port User’s Manual (W563)
12-
2 Proced
ure to
Use t
h
e SNMP Ag
ent
12
12-
2-1
P
rocedures
12-2 Procedure to Use the SNMP Agent
1
Make the basic settings.
Refer to
1-5 EtherNet/IP Communications Procedures
for the flow of basic operations.
2
Select
Built-in EtherNet/IP Port Settings
from the
Controller Setup
on the Sysmac Studio,
and then set the following on the SNMP Settings Display or SNMP Trap Settings Display.
•
SNMP Service
•
Recognition 1
•
Recognition 2
3
Select
Transfer to Controller
from the Controller Menu and click the
Yes
Button. The built-in
EtherNet/IP port settings are transferred to the Controller.
The following Built-in EtherNet/IP Port Settings are made from the Sysmac Studio to use the SNMP
agent.
12-2-1 Procedures
12-2-2 Settings Required for the SNMP Agent
Tab page
Setting
Setting conditions
Reference
SNMP Settings
SNMP service
Required.
Port No.
Specified by user.
Note
Required to change from the
default value of 161.
Contact, location
Specified by user.
Send a recognition trap
Specified by user.
Select this check box to send a recogni-
tion trap if there is access from an SNMP
manager that is not specified (Access
other than Recognition 1 and 2).
Recognition 1 and Rec-
ognition 2
Specified by user.
Make these settings to permit access by
only certain SNMP managers.
IP address
Host name
Community
name
Summary of Contents for Sysmac NY512-1300
Page 459: ......
