Omron Sysmac NX1P2-10 1 Series, User Manual

Page: 434 / 578

13-2 Procedure to Use the Automatic
Clock Adjustment Function
13-2-1 Procedure
1
Make the basic settings.
Refer to
1-5 EtherNet/IP Communications Procedures on page 1-28 for the basic operation
flow.
2
Select Controller Setup - Built-in EtherNet/IP Port Settings on the Sysmac Studio.
Set the following on the NTP Settings Display.
• NTP server settings (required)
• NTP operation timing
3
Select Synchronization from the Controller Menu. The built-in EtherNet/IP port settings are
transferred to the CPU Unit.
13-2-2 Settings Required for Automatic Clock Adjustment
The following Built-in EtherNet/IP Port Settings are made from the Sysmac Studio to use automatic
clock adjustment.
Tab page Setting Setting conditions Reference
NTP NTP server clock informa-
tion Required. page 5-10
Port No.
Specified by user.
*1
Server specifying method Required
IP address One of these must be set, depending on
the
Server specification type setting.
Host name
NTP operation timing Required
Specify a Time One of these must be set.
(Set according to the
NTP operation
timing .)
Specify a time in-
terval
Timeout time
Specified by user.
*2
*1. Required to change from the default value of 123.
*2. Required to change from the default value of 10 seconds.
Additional Information
Make the settings in the NTP Settings Display if automatic clock adjustment is used. Refer to
5-4 NTP Settings Display on page 5-10 for information on the NTP Settings Display.
13 Automatic Clock Adjustment
13-4
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)