Omron Sysmac NX1P2-10 1 Series, User Manual

Page: 61 / 578

SNMP Trap
When specific conditions occur, the built-in EtherNet/IP port that is set as the SNMP agent sends sta-
tus notification reports to the SNMP manager.
The SNMP manager can learn about changes in status even without periodically monitoring the built-
in EtherNet/IP port.
Status notification reports are sent under the following conditions.
• When the Controller is turned ON
• When links are established
• When an SNMP agent fails to be authorized
SNMP agent
Built-in EtherNet/IP port
Trap
SNMP manager
Controller
turned ON.
1-4-11
TCP/UDP Message Service
This function supports TCP/UDP socket communications, which allow simple access to CIP objects of
the Controller from a system where EtherNet/IP is not supported. This will allow you to change settings
and perform I/O control for NX Units connected to the Controller or the NX bus.
You can use the TCP/UDP message service only for the NX102 CPU Units.
1 Introduction
1-27
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User’s Manual (W506)
1-4 Introduction to Communica-
tions Services
1
1-4-1
1 TCP/UDP Message Service