Quick Start
MS-860 Industrial Raster Reader User’s Manual
1-7
Step 6 — Test for Read Rate
If you don’t have a test symbol, print out this page and use the symbol here for
testing.
Note: To the extent that the sweeping raster pattern extends above and below the
symbol, read rates will be diminished. To adjust raster pattern, see
"Raster Setup"
on
page 8-3.
By EZ Button
Press and hold the
EZ
button until one beep along with
a single green flash is emitted from the reader and the
20% LED turns ON.
Note: This assumes the
EZ
button is in its default
mode of operation.
By ESP
After connecting to the reader,
ESP will open in EZ Mode.
1. Click the
Test
button in EZ Mode to begin the read rate test.
2. Follow the instructions in
Easy Setup Mode screen.
3. To end the
Read Rate test, click the
Stop
button.
Note: If the reader is in the default Continuous Read mode and not in read rate or
calibration, it will read and beep repeatedly as long as a readable symbol remains in the
read range and the read cycle configuration has not changed.
By Serial Commands
From a terminal window,
Send an
<C>
to begin the read rate test.
Send a
<J>
to end the read rate test.
20 mil Code 39 Test Symbol
“20 mil” refers to the width of the nar-
rowest bar (e.g., 7.5 mil = .0075" or
.1905 mm).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com