Matrox Iris GT MIL, Installation And Technical Reference, Page: 37 / 256

Configuring your Matrox Iris GT to work with a network that uses static IP addresses 37
Configuring your Matrox Iris GT to work with
a network that uses static IP addresses
To add your Matrox Iris GT to a network using static IP addresses, perform the
following:
1. Contact your network administrator for a unique IP address for your Matrox
Iris GT and to determine the subnet mask for your network. Most networks have
IP addresses all on the same subnet.
2. Disconnect the Matrox Iris GT 100/1000 BaseT cable from your network.
3. Plug your Matrox Iris GT 100/1000 BaseT cable directly to your computer.
4. On your computer, launch the Matrox IrisBootParams utility. To do so, from the
Matrox Imaging submenu of the Windows Start menu, select Iris GT series . From
the presented submenu, select Matrox Iris GT utilities , and then click on
IrisBootParam utility.
❖
Note that the Matrox Iris GT utilities must be installed on your computer. If they
are not, refer to
Chapter 6: Installing application development software .