Matrox Iris GT MIL, Installation And Technical Reference, Page: 174 / 256

174 Appendix H: Matrox Iris GT utilities
FullRescue utility
The FullRescue utility rescues your Matrox Iris GT and restores it to its factory
settings or restores the previous backup created using the IrisBackup utility. Note
that this will remove any changes made since that point in time, and wipe the flash
disk clear. Before using the FullRescue utility, you should backup any files added
to the flash disk since the installation (or last full rescue) of your Matrox Iris GT
using the IrisBackup utility. For more information, refer to the
IrisBackup utility
subsection, later in this appendix.
You are prompted to confirm the operation before continuing.
Important It is essential that you don’t disconnect the power until after the Power LED and
User LED are green and your Matrox Iris GT finishes the rescue operation. This
can take up to 10 minutes. Prematurely powering down your Matrox Iris GT can
render your smart camera inoperable.
The files used to restore your Matrox Iris GT to its factory defaults are located in
the rescue folder of your Matrox Iris GT Utilities DVD. Note that you can move
these files to any location on your network, accessible by your Matrox Iris GT,
but if the files are renamed, the FullRescue utility will return an error.
❖
Note that it is strongly recommended that you save a copy of the Essential
Information page of the Matrox Iris portal website as a text file, before using the
FullRescue utility.
Before running this utility, you must stop any MIL applications running on your
Matrox Iris GT.
Syntax
\>FullRescue [DEFSET] [QUIET] {SharedFolder} {UserName} {Password}